Connecting the MIDI 1U to a Palette Case
You will need to connect the MIDI 1U to either a MIDI IN Jacks 1U module or to a case with built-in
MIDI/USB jacks. This section discusses how to connect the MIDI 1U to the MIDI/USB jacks on an
Intellijel Palette case.
1.
Turn off power to the Palette Case.
2.
Connect the supplied 10-pin-to-16-pin power cable between the MIDI 1U and one your case’s
16-pin power connectors (as discussed previously).
IMPORTANT: Be sure to plug power into the MIDI 1U’s POWER connector, and not the
other 10-pin connector, as illustrated earlier in
3.
Connect one end of the supplied 10-pin to 10-pin ribbon cable to the shrouded 10-pin port on
the MIDI 1U module. The connector is keyed, and will fit in only one direction.
4.
Connect the other end of the supplied 10-pin-to-10-pin ribbon cable to the shrouded 10-pin port
on the Palette Circuit Board. The connector is keyed, and will fit in only one direction.
The example on the right
illustrates the connection to the
circuit board on a Palette 62
case.
The example below illustrates
the connection to the circuit
board on a Palette 104 case.
5.
Power on the Palette Case.
The MIDI 1U module will now receive MIDI from the Palette’s MIDI IN jacks (both USB and
Type-A TRS-MIDI) and convert it to CV. In addition, the Palette’s MIDI OUT jack will function as
a MIDI Thru — passing along any MIDI data received at its MIDI IN jack.
MIDI 1U System Manual
9
