Intelligent UFM-B, Руководство по обслуживанию, Страница: 12 / 43

11
TO SET DECIMAL POINT
a. Press M+ when display shows dP and select the decimal place from
NIL to 3 decimal place
b. Press MODE to save and continue setup
TO SET CAPACITY AND GRADUATION
(For Single interval, it means Max x e; for Dual Interval, it means Max
2
x e
2
)
a. Press M+ when display shows CAP2 and utilize M+ to increase value,
MR to move cursor to the next digit
b. The graduation is limited to maximum of 1/6000 when type NTEP is
selected. It must be set to validate the change
c. Press MODE to save and continue setup
TO SET DUAL INTERVAL
(Max
1
x e
1
)
When type NORMAL is set, display will now show CAP1? to allow setup
for dual interval.
a. Press
M+
when display shows
CAP1?
and utilize
M+
to increase value,
MR to move cursor to the next digit. The default value is 50% of
the capacity set in CAP2 .
b. The graduation also must be set to validate the change
c. Press MODE to save and complete the setup
NOTE 1: You must reset capacity every time when you change the type
between NTEP and NORMAL.
NOTE 2: When NTEP type is selected, indicator will automatically
limit users to program the configuration under 1/6000. When
NORMAL type is selected, indicator will automatically allow
users to program the configuration under 1/30000.
NOTE 3: When setting up capacities, users must program all digits
including division before pressing MODE to complete set up.
2.4.5 Auto Power Off Setting (F4)
This unit is equipped with AUTO POWER OFF function. Default setting
= auto off after 4 minutes of idle time. Follow the steps below to
disable/enable the AUTO POWER OFF function.
a. Refer to the 2.4.1 on how to enter F4
b. Press MODE to shift between 0_OFF and 4_OFF