Intelligent Home Cronus, Инструкция по установке и эксплуатации

Страница: 18 / 22

-14-
All Monitors must have same User Code ‘0’ and programmed as Master/Slaves
Program first Monitor as Master, all others as Slave 1, Slave 2, Slave 3
If there are more than 3 Slave Monitors in the system, program them with different User Codes
starting with Code 0, 1, 2, 3, 4 and so on as for Star connection
In addition to User Code programming, last Monitor in the chain have to have DIP6 set On (end
of line). Applicable Intercom unction for Master/Slave programming- ‘Inner Call’- all Monitors
ring at the same time. Intercom by ‘Namelist’ requires different programming, same as for Star
connection
H ow to Program the ‘ Us er Code’ f or Star Connection
All Monitors must be connected to an additional hub-DBC4A distributor. One DBC4A can connect
up to 4 video Monitors. Each Monitor in the system should be assigned with the unique ‘User
Code’ according the tables on page 18 and have DIP6 set On in each Monitor in the system
H ow to Program the ‘ Us er Code’ f or Dai sy Chain Connection
ON(1)
=
OFF(0)
=
ON ON
ON DIP
1 2 3 4 5 6
DIP
state Setting
DIP
state Setting
1 2 3 4 5
6
ON DIP
1 2 3 4 5
6
ON DIP
M onitor not at the
end of bus line
M onitor at the end
of bus line
End of line
setting
with DIP-6
There are two way of connecting multiple Monitors:
1. Dai
sy
Chain - each Monitor connects to a next Monitor
2.
S
tar Connection - all Monitors connects to a central point
Up to 16 video Monitors can be connected in a House system. Up to 4 Monitors in each apartment
for Apartments system. Each Monitor in either system must be programmed with a ‘User Code’- the
address
Multiple Monitor System Configuration
There are two ways to program User Codes: via DIP-switches on the rear of the Monitor or
via ‘Address Setting’ page
INSTALLER SETUP
_
SW+ SW
- RING GND NC
1 2 3 4 5 6
ON
DIPS
L1
L2
01.00
Master