Intelix Audisey REM-PACK-8, Руководство по установке

Страница: 6 / 23

Intelix REM-PACK-8 Installation Manual
6 www.intelix.com
Connecting Data
The following steps detail connecting data to the remote controls once they are
wired and mounted in the electrical wallbox.
1) Open the ION-LT IR/serial controller packaging and mount the
ION-LT in a permanent location within 15 feet of the Intelix
Audisey Athena matrix mixer/amplifier or other serially controlled
hardware.
2) Connect the ION-LT to the controlled hardware with a prepared
serial cable (purchased separately).
¾ Pin 2 on the serial cable (RX) should be connected
to the phoenix-style style connecter conductor 2
(TX) on the ION-LT.
¾ Pin 3 on the serial cable (TX) should be connected
to the phoenix-style style connecter conductor 1
(RX) on the ION-LT.
¾ Pin 5 on the serial cable (GND) should be
connected to the phoenix-style style connecter
conductor 3 (GND) on the ION-LT.
3) Mount a CW-TB wiring block (found in each of the CB-1000
remote control packages) in a permanent location within 15 feet of
the ION-LT.
Preparing the Serial Cable
The ION-LT transmits serial control signals via a three
conductor phoenix-style wiring block. To connect to the
most serially controlled hardware (including the Intelix
Audisey Athena), you must create a custom cable with a
three conductor wiring block on one end and a standard 9-
pin RS232 connector on the other end. To create this cable,
follow the steps below:
1) Obtain a three conductor cable (15’ or less total
length) and a 9-pin serial (RS232) connector (pictured
below).
2) Solder the cables conductors to pins 2, 3, and 5. You
should now have a cable with a serial connector on
one end and three bare wires on the other. The bare
wires will terminate into the phoenix-style wiring
block on the ION-LT.