INTD1001-REV1
Function of each relay
1
simple press button
2 dialing with code
Dialing with code options:
1 Relay armed for determined time
2 Relay armed when code entered , relay disarmed when code re-entered (latch function)
Programming
Switching from a simple BUTTON to dialing with code
(a different code can be placed for each relay)
*ff*xxx*ccc*
for 3 digit code
*ff*xxx*cc*
for 2 digit code
where:
ff
= number of relay eg. 03 for the third relay
xxx
= old code (the factory preset code is 000)
ccc
= new code
eg. placing code 564 for second relay (for the first time)
the procedure is:
*02*000*564*
<change the old code 000 to new 564 for relay 2>
To change again:
*02*564*114*
<change the old code 564 to new 114 for relay 2>
Attention:
if the code of the relay 2 is 114 then you have to dial
2
114 to enable this relay.
Now the function of the particular relay is:
Code entered: Relay armed for the time determined by function *91* (delay time)
Switching from <dialing with code> to simple <press Button>
*ff*ccc**
Where:
ff
= number of relay eg. 02 for the second relay
ccc
= present code
eg *02*114*
Change the activation time of Relays
*91*ss*
Where
ss
= number of seconds
RELAY will remain armed for the time determined by
ss
( this function will change the activation time of
all
relays that uses delay time)
Latch Function
There is the ability of changing the function
<dialing with code>
to:
Code entered =Relay ON , code re-entered= Relay OFF
,as shown below:
*92*ff*
activating the function of locking RELAY
*92*ff#
deactivating the function of locking RELAY
Where:
ff
= number of relay
eg for the second relay
*92*02*
= enable Latch function for relay 2
*92*02#
= disable Latch function for relay 2
