Intel VCA1283LVV, Руководство пользователя по оборудованию

Страница: 25 / 29

Intel® Visual Compute Accelerator Product Specification and Hardware User’s Guide
19
If the add-in card does NOT meet these criteria, the given knock-out panel should NOT be removed.
When installing a double wide add-in card with a passive heat sink solution, remove only the plastic knock-
out from the side on which the add-in card is installed. Only remove both plastic knock outs when installing
two cards that meet the criteria defined above (1 per riser card). Once a knock-out panel is removed, it
cannot be re-installed.
 A system configured with the contents of Intel Accessory Kit AWTCOPRODUCT and an Intel ® Visual
Compute Accellerator card can also support the following additional PCIe* add-in card configurations.
o
PCIe* add-in cards with minimum 100 LFM (0.5 m/s) or 200 LFM (1m/s) air flow requirement can
be installed in any available add-in card slot in Riser Card #1, Riser Card #2, and Riser Card #3 (if
installed)
o
PCIe* add-in cards with a minimum 300 LFM (1.5 m/s) air flow requirement can be installed in the
bottom add-in card slot of Riser Card #1 and Riser Card #2.
o
PCIe* add-in cards with air flow requirement greater than 300 LFM cannot be supported

Systems configured with an Intel ® Visual Compute Accellerator card card must have a shipping bracket
installed before the system is exposed to any level of shock or vibration or is transported to the end user
location. Failure to install the shipping bracket has the potential to cause serious damage to various
components within the system.
The shipping bracket is only available as part of the following Intel
Accessory Kit: AWTCOPRODUCT .
Figure 10. Shipping Bracket