Intel SR2600UR - Server System - 0 MB RAM, Руководство по обслуживанию

Страница: 142 / 234

122 Intel
®
Server System SR2600UR/SR2625UR Service Guide
— If no power supply is to be installed, insert a power supply filler panel as shown
in Figure 115 .
Figure 115. Installing Power Supply Filler Panel into the Server System
Replacing the Power Distribution Module
To replace the power distribution module, follow these steps:
1. If installed, remove the PCI riser assembly. For instructions, see “Removing the
PCI Riser Assembly” on page 50 .
2. If installed, remove the processor air duct. For instructions, see “Removing the
Processor Air Duct” on page 56 .
3. Remove the large air baffle. For instructions, see “Removing the Large Air Baffle”
on page 70 .
4. Remove the fan module assembly. For instructions, see “Replacing a Fan Module”
on page 127 .
5. Disconnect all power cables from the server board, backplane, and midplane.
6. Remove the hot-swap power supply/supplies. For instructions, see step 1 in
“Replacing the Power Supply” on page 120 .
7. Remove the two screws to release the module (see letter “A” in Figure 116 ).
AF000023