Intel® Server System S9200WK Product Family Setup and Service Guide
42
4.6
System Battery Replacement
Required Tools and Supplies:
•
Anti-static wrist strap and conductive foam pad (recommended)
Before following the instructions in this section, remove the select compute module from the server chassis
(see Section 4.2.1), and then remove the riser assemblies from the compute module (see Section 4.3.1).
Figure 39. Removing the system battery
1.
Locate the battery on the server board. See Figure 39.
2.
Gently pull the metal clip to release the battery (see Letter A).
3.
Remove the old battery from the plastic socket (see Letter B).
4.
Dispose of the battery according to local laws.
5.
Remove the new lithium battery from its package.
6.
Orient the battery so the positive pole is facing towards the left side of the compute module.
Figure 40. Installing the system battery
7.
Insert the battery into the battery socket. See Figure 40.
8.
Use the <F2> BIOS Setup Utility to restore BIOS Settings and reset the system time and date.
