Intel® Server System S9200WK Product Family Setup and Service Guide
39
4.4.3
Drive Carrier Installation
Figure 34. Drive carrier installation into the chassis
1.
Align the drive assembly with the open drive bay.
2.
With the lever in the open position, insert the drive assembly into the drive bay (see Letter A) and
push forward until the drive makes contact with the internal backplane.
3.
Complete the drive installation by closing the drive assembly lever until it locks into place (see Letter
B).
4.5
M.2 SSD Replacement
Before following the instructions in this section, remove the selected compute module (see Section 4.2.1)
from the server chassis and then remove the selected riser assembly from the compute module (see Section
0).
This procedure applies to both 1U and 2U riser assemblies with illustrations showing differences where
applicable.
Required Tools and Supplies:
•
Anti-static wrist strap and conductive foam pad (recommended)
•
Phillips head screwdriver
