Intel Motherboard Raptor AT, Руководство по установке

Страница: 69 / 80

Appendix D: Industrial Devices
59
Table D-6 Uncompressed Initialization Codes
The following runtime checkpoint codes are listed in order of
execution. These codes are uncompressed in F0000h shadow RAM.
Checkpoint
Code
Description
03h
The NMI is disabled. Next, checking for a soft reset or a
power on condition.
05h
The BIOS stack has been built. Next, disabling cache
memory.
06h Uncompressing the POST code next.
07h Next, initializing the CPU and the CPU data area.
08h The CMOS checksum calculation is done next.
0Ah
The CMOS checksum calculation is done. Initializing
the CMOS status register for date and time next.
0Bh
The CMOS status register is initialized. Next,
performing any required initialization before the
keyboard BAT command is issued.
0Ch
The keyboard controller input buffer is free. Next,
issuing the BAT command to the keyboard controller.
0Eh
The keyboard controller BAT command result has been
verified. Next, performing any necessary initialization
after the keyboard controller BAT command test.
0Fh
The initialization after the keyboard controller BAT
command test is done. The keyboard command byte is
written next.
10h
The keyboard controller command byte is written. Next,
issuing the Pin 23 and 24 blocking and unblocking
command.
11h
Next, checking if <End or <Ins> keys were pressed
during power on.
Initializing CMOS RAM if the
Initialize CMOS RAM in
every boot AMIBIOS POST option was set in AMIBCP
or the <End> key was pressed.
12h
Next, disabling DMA controllers 1 and 2 and interrupt
controllers 1 and 2.
13h
The video display has been disabled. Port B has been
initialized. Next, initializing the chipset.
14h The 8254 timer test will begin next.
19h
The 8254 timer test is over. Starting the memory refresh
test next.