Intel M20NTP1UR, Руководство по системной интеграции и обслуживанию

Страница: 44 / 114

Intel® Server System M20NTP1UR - System Integration and Service Guide
44
3.10 Intel® VROC 7.5 Key Installation
This section provides instructions to install an Intel® VROC Key in the system. Refer to the Intel® Server
M20NTP Family Configuration Guide for available options,
Required Tools and Supplies
• Intel® VROC 7.5 Key – iPCs: VROCSTANMOD, VROCPREMMOD, VROCISSDMOD
•
Anti-static wrist strap and conductive workbench pad (recommended)
For more information on the Intel® VROC features, capabilities, and NVMe* drive population rules, refer to
the Intel® Server System M20NTP1UR Technical Product Specification.
1. Power off the system and disconnect the power cable(s).
2. Remove the system top cover (see Section 3.1.1 ).
3. Remove the Air Duct (see Section 3.2.1 ).
4. Remove the riser card assembly (see Figure 26 ).
5. Locate and unpack the Intel® VROC 7.5 Key
6. Locate the white 4-pin Intel® VROC Key connector found near the back edge of the server board.
7. Install the Intel® VROC 7.5 Key onto the server board (See Figure 46 )
Figure 46. Intel® VROC Key Installation
•
Position the Intel® VROC Key over the connector and ensure the alignment features of the key
and connector match.
• Place the Intel® VROC 7.5 Key onto the pins of the connector and press it down until it is
securely in place.