©
National Instruments Corporation
2-1
80188EB-Based Fieldbus Round Card User Manual
Chapter
2
Hardware Installation
This chapter contains instructions to help you install your Fieldbus
Round Card.
Warning: Several components on your Fieldbus Round Card can be damaged by
electrostatic discharge. To avoid such damage in handling the board, touch
the antistatic plastic package to a metal part of your computer chassis
before removing the board from the package.
Install the Hardware
Perform the following steps to install the Fieldbus Round Card.
1.
Connect the Fieldbus cable to terminal J2 (see Figure 2-1) on the
Round Card. The positive (+) end of the cable should be connected
to terminal 0A and the negative (–) end of the cable should be
connected to terminal 1A . Ensure that the Fieldbus cable is
properly terminated.
2.
Press the reset button on the Round Card, S1 (see Figure 2-1), to
reset the processor.
