Intel EtherExpress PRO 10+ ISA, Руководство по установке

Страница: 4 / 35

General information to read before installing
2 Press F2 to go to CMOS setup.
3 Set PNP OS to NO and reserve IRQ 5.
4 Save settings and boot to applicable OS.
5 Remote boot:
6 Remote boot fails HP tests on Vectra VEi7.
7 Message during boot on VEi8:
8 Message “EtherExpress PRO flash routines disabled. ROM shadowing
problem.” appears when warm or cold booting the system.
The work-around for the above issues is to disable Plug and Play on the
NIC using the Intel SOFTSET2 utility and to disable shadowing in the
CMOS for the address region used by the NIC flash ram. Both must be
done. Disabling only the shadowing will not fix the problem.
1 Boot into DOS 6.22.
2 Run Intel’s SOFTSET2 utility. Go to “View adapter configuration” and
take down the Flash chip address for later use.
3 Go back to main menu of SOFTSET2 and go to Change adapter config-
uration > Advanced Options menu > Set Plug and Play to Disabled.
For remote boot set Remote boot program to NDIS or Netware ODI de-
pending on the OS of the remote boot server. Save settings and exit
SOFTSET2.
4 The system will reboot.
5 Press F2 to go into CMOS settings. Go to Advanced > Shadow Options
> At a minimum, disable shadowing for the address region noted in
step 2. Save settings and exit SOFTSET2.
6 Reboot the system.
7 The Intel Flashstart configuration utility starts by default. Press the
spacebar twice to go to main menu > Exit. Note that after exiting, the
user will be given the option to start the Flashstart utility again on the
next reboot.
Another option to prevent the issues from occurring is to disable the
Flash memory feature on the NIC.
NOTE
This option disables remote boot.
1 Run Intel SOFTSET2 utility.