Thank you !
Thank you for choosing INTEK for your two-way business radios applications. This user friendly
transceiver will provide you with clear and reliable communications and will keep your professional
activities at peak efficiency. This transceiver incorporates the latest and most advanced technology, so
you will be pleased with its quality and its technical features.
Important notice !
The use of VHF and UHF FM transceivers is subject to the regulations applied in the country where the
product has to be used. As regulations are usually subject to possible modifications, please check the
current regulations in your country with your dealer or local supplier. INTEK does not take any
responsibility for illegal use and operation of this product not in accordance with the regulation of the
country where the product is used.
Safety notice
The user must know and understand the common risks related to the use of transceivers. Do not use
the transceiver in environments at risk of explosion (where there are gas, dusts, smokes, etc.). Do not
use the transceiver in service areas or fuel stations, on board aircrafts, etc.
Cautions
Please observe the following precautions, in order to avoid causing fire, personal injuries or damage to
the radio:
It is suggested that each transmitted message lasts a few minutes only, since very long
transmissions at the maximum transmitter RF output power may overheat the transmitter.
Do not alter or modify in any way your transceiver.
Do not expose the transceiver for a long time to direct sunlight and do not place it close to
heat sources.
Do not expose the transceiver to excessively dusty or damp places, do not place it on
unstable surfaces.
In case of anomalous smell or smoke that leaks out from the transceiver, turn it off immediately
and remove the battery pack. Please contact an authorised service center.
Please do not dispose off used battery with common garbage. Please use the dedicated
disposal containers.
If your vehicle is equipped with an airbag, do not place your transceiver device or other
accessories above the airbag or in the airbag deployment area. If in-vehicle equipment is
improperly stored or installed and the airbag inflates, serious injury could result. Radio frequency
signals might affect improperly installed or inadequately shielded electronic systems in motor
vehicles. Check with the manufacturer or its representative regarding your vehicle. If any
equipment has been added to your vehicle, you should also consult the manufacturer of that
equipment for information on radio frequency signals.
To assure optimal performance of the radio and in order to keep human exposure to radio frequency
electromagnetic energy within the guidelines, always adhere to the following procedures :
Two-Way Radio Operation
When using your radio, hold the radio in a vertical position with the microphone at a distance of
approximately 20 to 25 centimetres away from the lips. For PTT devices, the TX duty cycle is 30%.
- 2 -
General Information
English
Содержание MT-174W10
Страница 36: ......
