
Preliminary Steps
- 4 -
Battery charging
Connect the 230VAC adaptor charger to the desk type battery charger
and to a 230VAC outlet. The Green Led will light to confirm that the
charger is powered.
Insert the empty battery or the transceiver with the battery pack in the
battery charger. Please make sure that the charging contacts of the radio
are connected with the charging contacts of the charger cradle. The Red
Led will light then the device is ready to begin the charging process. The
charging time depends on the battery condition and capacity (about 5
hours). When the charging process has finished, the Red Led lights off
and the Green Led will light. Remove the battery pack or the transceiver
from the battery charger and disconnect it from the AC outlet
Charger LED Indicators
Warning !
The battery is supplied empty and it has to be fully recharged before use.
Make sure that the radio is switched OFF during charging process.
Some complete cycles of charge/discharge will be necessary in order for the battery to reach a
peak efficiency level.
Please do not charge the battery again when it has just been charged. Otherwise, you may
damage the battery or reduce its life.
The battery charger does not switch OFF automatically when charging is complete, therefore
please remove battery or radio from the charger cradle and disconnect it from the AC outlet.
Do not recharge battery for more than 8 hours, in order to avoid battery overheating.
Charger Status
LED Indicators
Remarks
Power ON
Red LED flashes for 1 second
then lights OFF
Standby Mode
Green LED lights ON
Charging Mode
Red LED lights ON
Full Charging
Green LED lights ON
Battery Fault
Red LED flashes
Battery voltage is lower than 6V
or battery pack is damaged
When the battery capacity is using out, the radio's red LED (6) will flash in red color and the radio will
keep reporting "Please charge the battery".
English
Содержание ET Series
Страница 36: ......