Integral Technologies FlashPoint 128 CPCI, Руководство пользователя

Страница: 75 / 92

79
Verifying Hardware and Software Setup (Cont.)
When FPG is started, video window is unstable or distorted.
Solution
Make sure video standard is properly selected: NTSC for 60 Hz cameras
or PAL for 50 Hz cameras.
When system is booted, VGA screen is blank.
Solution
Make sure your on-board VGA is disabled and any other VGAs are
removed.
Flash unit connected to FlashPoint 128 output trigger will not flash.
Solution
Make sure photocoupler connector from the FlashPoint cable is plugged
into the flash unit. Make sure that the flash unit trigger terminal has a DC
operating voltage of less than 60 volts. Some flash units will have more
than 200 volt operation; the output trigger circuit on FlashPoint 128 will
not function at those levels. Make sure the jumpers are configured
properly for your specific flash unit.
Video will not capture when remote switch is pressed.
Solution
Make sure of the connection of the switch between GND and Pin 9 on
the DB25 connector. Also make sure the remote grab control is enabled
in the tools configuration menu.