2
3
Functions and Operating Instruction
A: Please note
a) The LED Dimmer/ Receiver operates on 5V to 24V DC (Ensure
that the LED DRIVER and LED STRIP operate at the same
voltage)
b) The LED Dimmer/ Receiver only supports CONSTANT VOLTAGE
LED DRIVERS
c) Ensure that the LED DRIVER is suitable to power the length and
type of LED
d) For proper operation with the remote control. Do NOT enclose
the LED Dimmer/ Receiver in metal e.g. metal trucking
e) Ensure that the LED Dimmer/ Receiver unit is installed in a
good heat dissipation environment to avoid overheating. Keep
the unit away from moisture.
B. Pairing New Remote
To pair a new remote control:
1). Turn OFF the mains power to the LED DRIVER and turn ON
after 5 seconds.
2). Press the ‘100%’ and ‘60%’ keys simultaneously within 5
seconds of power ON, the indicator will flash white 3 times to
confirm the command has been accepted, the LED Dimmer/
Receiver will now function with the new remote control. Only
the last three paired remote controls will be recognised.
OPERATING INSTRUCTIONS
A. Remote Battery
Please remove the battery installation tag before use. The
remote control uses a CR2025 cell battery; it can last for up to 2
years with normal usage.
B: Wiring
The LED Dimmer/ Receiver is wired in between the LED DRIVER
and LED STRIP. Install the LED Dimmer/ Receiver in accordance
with the wiring diagram (fig 1). Please pay attention to polarity.
RED = positive (+), BLACK = negative (-). Ensure that the mains
power is OFF and cannot be connected unexpectedly during
installation.
C: The LED Dimmer/Receiver Status Indicator
The LED Dimmer/Receiver has output short circuit, overload and
overheat protection function, if the LED Dimmer/ Receiver stops
working please check the circuit for a short circuit or overload.
The full colour status indicator - displays all working statuses
of the controller. It indicates different functions as below. The
controller will automatically recover from the protection mode
when a good working status is restored.
Fig. 1
Blue
Normal working
White Flash – Short Single
New command received
Yellow Flash – Long Single Reached brightness limit
Red Blinking
Overload/short circuit protected
Yellow Blinking
Overheat protected
DC 5V-24V
DC 5V-24V
(Red)+
(Black)-
(Red)+
(Black)-
+
One remote per device.
Up to three remotes per device.
One remote to control multiple devices.
