a.
prep vehicle
8
6. reMOve trunk rear sill
Remove the trunk rear sill by removing the (4) center pin expan-
sion clips along the inner side. Lift the lower front edge of the sill
forward to clear the D-rings, then give a firm lift up to release the
friction clips holding the upper portion.
7. fOld dOwn driver side rear seat
Pull the rear seat release located in the trunk, fold down the driv-
er-side rear seat.
8. reMOve driver-side rear Quarter panel triM (step 1)
Locate the luggage D-ring tie down at the forward driver-side of
the trunk. Pry off the black plastic cover. Remove the Torx T-40
screw. Lift out the D-ring assembly.
9. reMOve driver-side rear Quarter panel triM (step 2)
There are (3) center-pin expansion clips that fasten the rear quar-
ter panel trim to the car - locate & remove the one in the upper
part of the rear cubby area.
10. reMOve driver-side rear Quarter panel triM (step 3)
Then locate & remove the one on the side, under the parcel shelf
area. This one is attached to a plastic bracket. Remove the ex-
pansion clip on the upper portion of the bracket, and leave the
bracket attached to the quarter-panel trim.
