e.
sO
undst
age
21
71. install iass-t1c tweeter
Connect the wiring termials to the tweeter tabs. Be careful not
to bend the tabs - work them side to side and slide them on until
they are fully connected/locked, with no tweeter tab remaining
exposed. Gently bend the attached wire-terminal inward at an
angle. Be sure the clear vinyl terminal boot is isolating the tab/
terminal from the metal housing of the tweeter.
72. replace upper dOOr triM
Replace the foam insert behind the tweeter and re-attach the up-
per door trim. The wiring harness should be run as shown, and
clear of the midrange driver as well as any pinch points or clips.
Use two of the
4” Black Zipties
from the
Midrange, Tweeter, and
Crossover Hardware Kit
to secure the wire bundle.
73. replace dOOr panel
Insert door lock indicator (1) thru hole. Then align the five clips
along the top of the panel (2). Wiggle the panel slightly to be sure
all clips are aligned. Give a firm strike over each clip to lock in
place. Repeat for the remaining door clips. TIP: a bit of masking
tape on the panel in the location of the clips can help locate them.
Do not finish re-installing the panel until after testing!
REPEAT THE PREVIOUS 21 STEPS FOR THE OTHER SIDE
74. lOOsen the driver side rear seat BOttOM
NOTE: The next steps cover the Subwoofer Remote Volume Control
installation. If you are not installing the subwoofer now, but plan to in
-
stall it later, we recommend installing the Remote Volume Control now.
Otherwise, skip to Step 93 “Remove Plastic Cover Panel”.
Raise the drivers-side rear seat back up. Pull up firmly on the
front edge of the rear seat bottom (1) to release. Prop the seat
bottom up 6-8”.
75. reMOve rear dOOr sill triM (step 1)
Remove the center pin expansion clip (1). Remove the Door Sill
Trim panel (2) by pulling up firmly to release the four clips below
(3).
Release the rear seat back again and lean it down on the propped
up seat bottom.
[subwoofer oNLY]
[subwoofer oNLY]
