6
Assembly of the UltraLite
®
Pro Headlight System
Next open the headlight assembly fully by pulling the
central unit (Fig 7) completely open and opening the
circumferential adjustment (Fig 8) fully.
The pad (Fig 9) should be at the front of the headlight
Place the headlight on your head. The occipital basket should
be aligned (Fig 10) as shown.
Grasp the headlight as shown (Fig 11) and push the headlight
from front to back until it fits snugly. Adjust the pad front to
back (Fig 12) for a more comfortable fit
The headlight should then be adjusted circumferentially using
the ratchet knob at the rear as shown (Fig 13). The UltraLite
®
Pro headlight is now ready for use.
The headlight system comes with two gown clips to relieve the
weight of the fiber optic cable from the head. One clip should
be attached to the surgical gown or scrubs at, or just below
shoulder level (Fig 14).
Be sure to leave enough slack in the cable to allow for
freedom of head movement. If the surgeon needs to detach
the cable from the light source, the second gown clip is used
to attach the cable to the gown or scrubs to eliminate the risk
of dropping the cable.
The spot size of the light may be adjusted from 20 – 100mm
(0.8 – 4 in), based on a 46cm (16 in) working distance, by
adjusting the iris (Fig 15).
(Fig 7)
(Fig 8)
(Fig 9)
(Fig 10)
(Fig 11)
(Fig 14)
(Fig 12)
(Fig 15)
(Fig 13)
