Integra DTR-40.5, Инструкция по эксплуатации

Страница: 73 / 104

Advanced Operations
En-73
Operating
procedure
(
➔
page 55 )
■
MAC Address
This is the AV receiver’s MAC (Media Access
Control) address. This address cannot be changed.
■
DHCP
`
Enable
`
Disable
This setting determines whether or not the AV
receiver uses DHCP to automatically configure its IP
Address, Subnet Mask, Gateway, and DNS Server
settings.
Note
• If you select “ Disable ”, you must configure the “ IP
Address ”, “ Subnet Mask ”, “ Gateway ”, and “ DNS Server ”
settings yourself.
■
IP Address
`
Class A:
“ 10.0.0.0 ” to “ 10.255.255.255 ”
`
Class B:
“ 172.16.0.0 ” to “ 172.31.255.255 ”
`
Class C:
“ 192.168.0.0 ” to “ 192.168.255.255 ”
Enter a static IP address provided by your Internet
Service Provider (ISP).
Most routers use Class C IP addresses.
■
Subnet Mask
Enter the subnet mask address provided by your ISP
(typically
255.255.255.0 ).
■
Gateway
Enter the gateway address provided by your ISP.
■
DNS Server
Enter the DNS server address provided by your ISP.
■
Proxy URL
To use a Web proxy, enter its URL here.
■
Proxy Port
If you’re using a Web proxy, enter a proxy port
number here.
■
Network Standby
`
On
`
Off
This setting enables or disables control over the
network.
When enabled, the
NET indicator will be dimly-lit
while the AV receiver is in standby mode. Note that
the indicator may not light under certain conditions
(
➔
page 21 ).
Note
• When set to “ On ”, the power consumption slightly
increases in standby mode.
■
Update Notice
`
Enable
`
Disable
When this setting is enabled, you will be notified if a
firmware update via network of high importance is
available.
Note
• Selecting “ Never Remind me ” on the notification window
will switch this setting to “ Disable ” (
➔
page 21 ).
• For details on the update notification, see “Firmware
Update Notification” (
➔
page 21 ).
■
Bluetooth
This setting enables the AV receiver to pair with
Bluetooth-enabled device.
Status
Press Enter button to display “ Now Pairing ” and start
pairing.
Tip
• If pairing setting is not set, “ Ready ” appears on-screen
display. The name of the device paired with the AV receiver
is displayed if pairing setting is set.
• For details on the Bluetooth connection, refer to the
instruction manual of the Bluetooth-enabled device.
Note
• This setting cannot be selected if you’ve selected NET or
USB as input selector in Multi Zone.
Initial Setup
If you skipped the initial setup wizard, for example on
first-time use, you can reaccess it from here.
See “
Initial Setup ” (
➔
page 21 ).
Note
• This setting cannot be selected if the “ Monitor Out ” setting
is set to “ Sub ”.