Instruction Manual
|
6
Set up and Operation
Please note that all VORTEC CANNON’s are tested prior to shipment. Each system has 5W30 oil
installed. It is recommended to check engine oil and fill with oil as required prior to each day’s use.
Refer to Vanguard’s engine manual for recommendations regarding oil use and timing to change.
The Vanguard Commercial V-Twin engine used with each VORTEC CANNON high-powered vacuum has
an Oil Pressure Switch which will prevent the engine from starting when oil is low. To ensure long
engine life and avoid the inconvenience of not being able to start, check oil prior to each use and
ensure oil is fill to the upper limit.
System Set-Up:
1.
Periodically check all fasteners for tightness. Due to the natural vibration associated with
vacuums, some fasteners may become loose over time.
2.
Obtain appropriate protective equipment.
3.
Set system on a dry, level surface.
Note: The incline position of the engine should not exceed 20 degrees in any direction. If it
does, oil can mix with the gas causing harm to the engine.
4.
Attached vacuum hose to the inlet pipe using a hose clamp.
Note: If using a VORTEC vacSHIELD, install the vacuum hose to the inlet of
the VORTEC vacSHIELD. Then connect a piece of vacuum hose from the
VORTEC vacSHIELD’s outlet to the vacuum’s inlet.
5.
Attach hose or vacuum bag to the machine’s outlet using a hose clamp.
System Operation:
1.
Review Vanguard’s engine manual prior to starting the engine to review safety and operation
procedures.
2.
Remember when stopping engine, slow engine and let idle for a few minutes prior to stopping.
This shut-down methodology is good for your engine. Please avoid shutting the engine from a
state of fast throttle (and associated high operation speeds) to off.
3.
Hour meter operation – Please reference Tiny Tach’s on-line instructions at
http://tinytach.com/installation-gas.php.
