- Segment conveyor-page 4.2
Transport & assembly
4.
4.
4.4 Assembly, electrical and pneumatic connection
The delivered segment conveyor is completely assembled and must only be integrated into the
control mechanism of an existing system. Furthermore, electrical power supply must be ensured.
Installation of the segment conveyor using the vibration dampers is sufficient. However, we
recommend a fixed installation. After disassembly of the vibration dampers, eight M6 threads for
fixed installation can be found in the base plate underneath the segment conveyor.
Electrical connection and actuation via the customer-provided control takes places via a 25-pin
SUB D bushing.
The pneumatic connection takes place via a 8 mm plug coupling.
The complete electronics and pneumatics (valves, sensors, etc.) are wired and with all piping by
the manufacturer in the inside of the housing. For exact connection wiring of your segment
conveyor refer to the enclosed terminal and PIN diagram.
In case of malfunctions, the system must be disconnected from the power supply.
All connections are by default connected to a terminal. For cable penetration into the segment
conveyor housing, a slot is located at the backside of the housing. Ensure a sufficient supply
diameter. The connection cable must be equipped with a properly connected protective earthing
conductor.
WARNING
Compressed air connection:
8 mm plug-in coupling
Quality: dried, filtered and unoiled
Operating pressure: 6 bar factory setting
Electrical connection:
Power supply connection: 25-pin SUB-D
bush
Control voltage: 24 V DC
Nominal current: min. 1 A
Supply diameter: 25 x 0.14 mm
2