© INTEC Video Systems, Inc.
Revision F May 2013
7
Installation Instructions
Your Car Vision® System should be installed so the
ignition switch or power switch that controls your
vehicle’s power also provides power to the Car
Vision® System. To be in a constant ready state, the
Car Vision® System consumes a small amount of
power even when it is in Standby mode. Therefore,
connecting the system to a pre-ignition constant
power source or directly to the battery can drain your
vehicle battery.
The Car Vision® System is designed so that the rear
mounted Car Vision® camera can have priority over
any other camera or data input into the display
provided the blue reverse gear power source lead is
properly connected and the rear camera is
connected to the Camera 1 position. (Please see the
Wiring Diagram provided with your controller).
When the vehicle is placed in reverse, the rear
mounted camera will be activated and the picture it
provides will be shown on the display screen.
Always confirm proper operation before travel. In
multiple camera systems, other camera views can
also be triggered automatically within a priority
scheme. If you have any questions regarding the
proper installation or operation of your Car Vision®
System please call INTEC @ 800-468-3254 (west)
or 800-522-5989 (east)
Wiring Diagram
(Refer to the Wiring Diagram provided with your controller
or see the Wiring Diagram for your controller on the
Operators CD.)
Display Connections
1 – Connect cable CVDC6MA (from controller)
2 – Connect the Remote Control directly or use
the optional 5 meter extension cable
(CVDR5MA).
Display and Controller Installation
The display should be mounted where it is easily
viewed and accessible to the driver but not in an
area that may block or impede the drivers and/or
passengers airbags. For a dual drive vehicle, the
display and remote should be placed where they are
accessible from both the left and right side driving
position. (An optional swivel base is available.) The
display should also be mounted in a fashion that
would prevent glare from sunlight affecting the
image seen on the screen. It can also be easily flush
mounted into a cut out in the dash or overhead
console. Generally, overhead center is a good
location, but you should determine what location is
best for your particular installation. Do not obstruct
forward visibility.
Prior to installation, make sure the display does not
block the driver's forward or side view in any way.
1. Locate the area in the cab that best
accommodates the driver and the application. You
will want to make sure the location chosen is
adequate to support the display (a metal surface is
recommended). In cases where the mounting
surface is plastic, support braces may be required.
2. Once you have located the preferred mounting
position, use the mounting bracket supplied with the
display as a template for drilling the holes required
to hold the display in place. When a swivel base is
required, use it as your template. Be sure to verify
that the area being drilled into is cleared of all wires
and other items around or underneath so as not to
damage anything.
3. After the holes have been drilled, mount the
bracket with the hardware provided. In some cases,
the hardware provided may not work in your
application. You may need to purchase additional
hardware for your application.
