© INTEC Video Systems, Inc.
Revision F May 2013
4
Warnings and Cautions
Warnings
Do NOT attempt to connect other
electrical devices to the power wire
harness of the Car Vision® System
as this can cause an over current
situation which can lead to electrical
shock or fire.
If at any time you see or smell smoke
coming from the Car Vision®
System, stop driving, exit the vehicle
and disconnect main power. Check
the system and remove any
damaged components before you
resume normal vehicle operation.
Do NOT attach the wiring to any
moving parts, across sharp edges or
close to heat sources as this may
cause shorting of the wires and may
lead to a fire or electrical shock.
When installing the camera system
be certain that all items are secure.
Items that are not secure or mounted
in an unstable manner can come
loose and cause damage or personal
injury.
When installing the system be sure
to use only INTEC supplied brackets.
The Car Vision
®
camera must be
insulated from the vehicle body. The
supplied camera bracket provides
the required insulation. Failure to do
so could result in a fire and lead to
property damage or personal injury.
Do NOT install the camera in any
area that allows it to extend out past
the vehicle as this can cause injury if
it were to come in contact with
people walking around the vehicle.
Never use fuses of a larger rating
than those supplied with your Car
Vision® System. Use of larger rated
fuses can cause excessive current
through the system if a short occurs
and could lead to a fire.
Cautions
Confirm that the orientation of the
image on the display is proper. Rear
facing cameras should yield a mirror
image, where items on the left of the
vehicle appear on the left side of the
monitor.
Before you begin driving, be sure the
display controls are adjusted
properly. This will avoid unnecessary
distractions while driving.
Do NOT attempt to open or service
your equipment. Removal of the
product enclosure can lead to
electrical shock.
You should not attempt to make any
adjustments to the Car Vision®
System while driving as this can lead
to an accident. Only make
adjustments when the vehicle is
stopped.
Keep the Car Vision® System clean
and free from dirt, snow and ice. If
the camera glass or display panel
becomes dirty, clean them before
use. If they are covered with snow
and/or ice, it should be cleared off
before use. Failure to do so could
lead to an accident.
When running a cable from the
exterior to the interior of a vehicle,
care needs to be taken to seal the
entry point. Failure to do so could
allow in exhaust fumes, other toxic
gases or water.
