AirGate-Modbus
INTAB INTERFACE-TEKNK AB
19/22
identifies the device on the network. As a standard, since it is a gateway
and to not conflict with other network devices, all of the AirGate-Modbus
leave the factory with the address 248.
When in configuration mode, as explained in the
Configuration Mode
chapter, the device always answers for the Modbus 246 address using
the USB interface.
33
When operating in Multi-Master mode, as explained in the
MULT-
MASTER
chapter, the gateway uses the
Multiplexar
function that needs
a time-out to release the interface in case the response does not return
to one of the masters.
The Time-out is configured in this register. This is the maximum amount
of wait time for a response from a slave
300
65535
R/W
34
Used to configure the transmission power of the Wireless interface. The
larger the configured value, the greater the reach.
0 – 0 dBm,
1 – 2 dBm
2 – 4 dBm
3 – 6 dBm
4 – 8 dBm
5 – 10 dBm
6 – 12 dBm
7 – 14 dBm
8 – 20 dBm
R/W
35
Indicates the operation channel which can vary from 11 to 25, According
to Anatel guidelines, the device can operate in the frequencies of
channels 11 to 25 for power levels of up to 20 dBm.
11
25
R
36
LQI RX Father Register
Lists the LQI RX Father, i.e., the quality of the reception link to the
network father. The LQI Rx is a power measurement of the last packet
received by the father. This amount is measured in dBm and varies
between -100dBm (worst reception quality) to -15 dBm (best reception
quality). This register has a value of 0 when the device is in configuration
mode or is the network coordinator (that does not have a father).
-100
-15
R
37
Indicates the number of children (AirGates in operation mode RS485-
RHTs-Air) that the device has.
0
43
R
38
ADDR_FILHO register.
This register is used to request the AirGate-Modbus information about
its children.
This register should include the Modbus address of the child that
requires the information contained in the registers
39
to
48
.
The information will only be filled out is the Modbus address
corresponds to a device that is in a branch below the one the father
belongs to.
If the Modbus address does not belong to a direct child, the information
will correspond to the child en route to the destination.
0
255
R/W
39
LQI RX Child Register.
States the LQI RX Child, i.e., the LQI of the last packet received by the
AirGAte of the child en route to ADDR_FILHO. If ADDR_FILHO is of a
child, the LQI corresponds to it, otherwise, the LQI corresponds to the
child
of
Short
Mac
ROTA_FILHO_SHORT_MAC_0
ROTA_FILHO_SHORT_MAC_1.
-100
-15
R
40
States the number of packets requested to the child with the address
ADDR_FILHO as long as AirGate has started until reaching the limit of the
register.
0
65535
R
41
States the number of packets answered by the child with the address
ADDR_FILHO as long as AirGate has started until reaching the limit of the
register.
0
65535
R
42
Lists the error rate in % * 100.
To obtain the error rate in %, divide the register value by 100.
0
10000
R
43
States the size of the last requested packet to the child with the address
ADDR_FILHO.
0
4096
R
44
States the size of the last requested answered by the child with the
address ADDR_FILHO.
0
4096
R
