6. Install Parent and Child Tray
Open the canopy. Snap the parent tray on to the handlebar tubes (Figure 6).
Guide the child tray tabs into the slots on the stroller frame. Push until tray clicks
into place (Figure 6a). To remove the tray, lift up on the tabs of each side of the
tray and pull the tray off (Figure 6b).
7. Folding the Stroller
Before folding the stroller, close the canopy remove the child from the stroller.
To fold the stroller, slide the red lever on the handlebar to the left and squeeze.
Hold the button in and push the handlebar down. The stroller should fold flat.
Hook the red tab to the frame of the stroller to keep the stroller folded. You may
need to raise the backrest by hand to fold easily.
4. Install Front Wheel
Slip the front wheel on to the front fork. Make sure that the small hooks/tabs on
the washers are hooked in the corresponding holes on the fork. Tighten the nut
down with the included spanner wrench (Figure 4). Repeat for the other side.
Do not over tighten the nuts.
NOTE:
This product has a swivel wheel that can rotate or be locked in place. To lock
or unlock the wheel use the switch placed on the top of the fork to toggle between
jogger and stroller mode. The wheel should always be locked in place when used as
a jogging stroller.
5. Install Front Fender
Insert the top of the front fender so that the top lies under the bottom of the seat.
There are two elastic loops at the bottom of the seat (Figure 5). Insert the elastic
loops through the provided holes in the fender.
Flip the stroller upside down. Attach the elastic loops to the pegs on the under
side of the fender (Figure 5a). Also, insert the two provided screws into the
holes on the frame (Figure 5a) so that they line up with the provided holes in the
fender. Tighten down with a Phillips screwdriver.
Operating Instructions
Suburban Safari
™
...page 3
(Figure 4)
(Figure 5)
(Figure 5a)
loop
hole
loop
screw
(Figure 6)
(Figure 6a)
(Figure 6b)
(Figure 7)
(Figure 7.a)
Suburban_Manual_110706_b.indd 3
9/25/07 2:21:21 PM
