![background image](http://html1.mh-extra.com/html/insteon/controlinc-2430/controlinc-2430_owners-manual_2069905010.webp)
ControLinc Owner’s Manual
Restoring Power to ControLinc
ControLinc stores all of its settings, such as Links to other INSTEON devices, On-Levels/Ramp Rates,
etc., with non-volatile memory. Because settings are saved in this non-volatile memory, they will not be
lost in the event of a power failure.
Resetting an On/Off Button Pair to its Factory Default Settings
If you want to remove all INSTEON Links from a single On/Off button pair or if you cannot Unlink a
previously-Linked Responder that has been lost or broken, follow this procedure.
1) Unplug the ControLinc power cord for at least 10 seconds
2) While holding down the Off button of the On/Off button pair that you want to reset, plug the
ControLinc power cord back in
ControLinc should beep and its Status LED should flash twice and then turn on
3) Wait 3 seconds, and then release the Off button
The ControLinc Status LED should flash once
4) Test that the On/Off button pair no longer controls any Responders by tapping the On and Off buttons
Responders should no longer respond
Resetting ControLinc to its Factory Default Settings
The factory reset procedure will clear ControLinc of all INSTEON Links and any programmed X10
addresses.
1) If you are using ControLinc to control any INSTEON devices, Unlink those devices from ControLinc.
See
Unlinking an INSTEON Responder from ControLinc.
2) Unplug the ControLinc power cord for at least 10 seconds
3) While holding down the Bright button, plug the ControLinc power cord back in, making sure not to let
go of the Bright button
ControLinc should beep as you plug it in and the Status LED should flash, and then turn on solid
4) Continue to hold down the Bright button until it double-beeps
The ControLinc Status LED should flash again, and then turn on solid
5) Test that ControLinc no longer controls any Responders by pressing each of the buttons
Page 10 of 15