Page 12 of 13
2634-222 - Rev: 2/11/2019 9:16 AM
Phase Bridge Detect Beacon/RF Range Test
On/Off Outdoor Module automatically bridges the electrical phases in your home (via communications with other
dual-band devices on the “other phase”). This is only important in 2-phase homes with powerline-only INSTEON
products or buildings with both 2- and 3- phase circuits. The phase bridge detect beacon can also be used as an
RF range test to see if your devices are within communication range. You will need at least one other INSTEON
dual-band device installed.
1) Quickly tap Set button four times
On/Off Outdoor Module will start beeping once per second
LED will turn solid green
2) Check the LED behavior of other dual-band devices
Phase Bridge Detect Beacon
If the other dual-band device is blinking
green, it is on the other phase:
Device provides a phase bridge to Micro module
If the other dual-band device is blinking red, it is on the same phase:
Device does not provide a phase bridge to Micro module
Relocate if necessary (and practical)
If the other dual-band device is not blinking:
Device is not within RF range of Micro module so it does not provide a phase bridge
Relocate if necessary (and practical) or add an additional dual-band device
RF Range Test
RF range test: if LED is blinking:
Device is within RF communication range
RF range test: if LED is not blinking:
Device is not within RF communication range
Relocate if necessary (and practical) or add an additional dual-band device
3) Tap Set button
On/Off Outdoor Module will stop beeping
Other device LEDs will stop blinking
Factory Reset
All settings, links and scenes will be erased.
1) If you are using a controller to control On/Off Outdoor Module, be sure to unlink it from the controller
2) Unplug On/Off Outdoor Module
3) While pressing and holding Set button, plug On/Off Outdoor Module back in. Do not let go of set button.
On/Off Outdoor Module will begin to emit a long beep
Status LED will turn green
4) When long beep stops, release set button
Status LED will flash red and then turn green
After a few seconds, load will turn on
