Go to http://install.instar.com
6-EN
4.3. Status LEDs
01 - Antenna Connector RP-SMA WiFi antenna connector (incl. 3dB antenna)
02 - MicroSD Card Slot
Slot for MicroSD/SDHC cards (max. 32GB - 8GB included)
(already installed inside the camera)
03 - Infrared LEDs
5 High-Power IR LEDs (nightvision @ 850nm)
04 - Lens
4mm CS-Mount lens with a ~90º diagonal field of view
05 - Photosensor
Twilight switch for IR LEDs
06 - Audio output
Chinch-connector for optional active loudspeakers
07 - Alarm input
Input for potential free external alarm sensors
08 - Alarm output
Output (relay) can support max. 24V/1A
09 - Audio input
Chinch-connector for optional active speakers
10 - WPS / Reset
3 seconds for quick WiFi setup / 15-20 seconds for reset
11 - Power Connector
12V / 2A DC - Plug Ø : 2,1mm (in) / 5.5mm (out)
12 - Network Port
RJ45 LAN-port / connector for Cat5e LAN cable or higher
Please refer to below 4.3 for Status LEDs
13 - Camera Label
P2P ID, LAN MAC address and serial number (located at the
backplate)
Status LED
Green LED
Orange LED
Constant on
-
Network cable is connected or
in WiFi mode
Slow Flashing
-
-
Fast Flashing
Data transfer through LAN
-
Off
No network cable connected
or in WiFi mode
Network cable is not connected
correctly
