6
Installation instructions & user guide
T210042 InstaTap office manual v1.01 June 2022
SECTION 3 WARNINGS & REGULATORY INFORMATION
• Connect only to a potable (wholesome, cat1) mains water supply.
• Never locate the system near, or clean with water jets.
• Do not expose the InstaTap system to the elements of nature.
• A pressure limiting valve must be fitted for mains water pressures above
the max. limits stated.
• Use of tools can be hazardous, assess the risks before you start.
• A clearance envelope around the under counter appliances must be
provided to allow adequate ventilation and service access for their safe
and effective use.
• Valve and fitting threads must be sealed appropriately with PTFE tape
where compression seals are not provided.
• Do not over tighten plumbing and hose connections.
• The power cords and power outlets must be in a safe and accessible
position after installation. When positioning the under counter
appliances, ensure power supply cords are not trapped or damaged.
If damaged they must be replaced by an Instanta service provider or a
qualified electrician.
• Instanta cannot be held responsible for any appliance malfunction if
the water pressure exceeds that stated. If in doubt, consult your water
supply company.
• The install rail supplied must be fitted to ensure compliance with the
S.I.1999 No.1148 The Water Supply (Water fittings) Regulations 1999
Schedule 2 requirement.
• Ensure that all installed silicone tubes are shaded from direct sunlight.
• Instanta cannot be held responsible for limescale related problems even
when a limescale reducer has been installed.
• As with all refrigeration systems, irreparable damage can be caused by
laying the chiller on its side or even transporting upside down.
• If the under counter chiller has been transported incorrectly, it should
be placed in the correct upright position and left for 24hours before
attempting to install and commission it. Failure to observe these
precautions could seriously damage the refrigeration system.
