Insta 907, Руководство по эксплуатации и обслуживанию

Страница: 7 / 22

FOR USE BY QUALIFIED PERSONNEL ONLY
Controller Operation
1. Select the desired preset program by pressing
the
PGM button until the LED above the PGM
button indicates the desired setting.
2. If a setting other than the programmed presets
are desired, press the
PGM button until none
of the LED's above the PGM button are lit.
3. Changing the Temperature
• Press the MODE button until
temperature is displayed.
• Press and hold SET button in while
pressing the UP (
↑
) or DOWN (
↓
)
arrow buttons to the desired
temperature setting.
4. Changing the Time
• Press the MODE button until timer is
displayed.
• Press and hold SET button in while
pressing the UP (
↑
) or DOWN (
↓
)
arrow buttons to the desired timer
setting.
NOTE
For operator safety the machine is
designed not to operate unless the
upper arm is directly over one of the
lower platens.
NOTE
When the machine is operating with
none of the LED’s lit, i.e. no presets,
the time and temperature will be saved
even if the power is turned off. The
presets will also be saved when the
power is turned off.
NOTE
The DISENGAGE switch (located in
the center of the instrument panel)
may be pushed at any time to
deactivate the machine.
6
Setting the Presets
1. Push and hold both the MODE and PGM
buttons for 3-5 seconds until one of the
programs LED's starts to blink. This is the
programming mode.
2. A blinking LED above the PGM button
indicates which preset is active.
3. Select a program (1,2,3,4,or 5) by pressing
the PGM button.
4. Setting Temperature
• Press the MODE button until
temperature is displayed.
• Press and hold SET button in while
pressing the UP (
↑
) or DOWN (
↓
) arrow
buttons to the desired temperature
setting.
5. Setting Time
• Press the MODE button until time is
displayed.
• Press and hold SET button in while
pressing the UP (
↑
) or DOWN (
↓
) arrow
buttons to the desired timer setting.
6. Repeat steps 3-5 until all five (5) presets
have the desired preset (temperature/time
cycle).
NOTE
If a Fahrenheit/Celsius change is
desired, see
Additional Notes –
Temperature .