3
Safety Introduction
14.
The equipment is intended for installation in a Restricted Access Location.
Note:
The following considerations may help avoid the occurrence of problems that
could damage the components or cause data loss, etc.
1.
In the event of the following, please unplug the power line plug from the power
socket and contact Inspur’s customer service department:
1)
The power cables, extension cables or power plugs are damaged.
2)
The products get wet.
3)
The products have fallen or have been damaged.
4)
Other objects have fallen into the products.
5)
The products do not or are unable to function normally even when attempting to
operate according to the instructions.
2.
If the system becomes wet or damp, please follow these steps:
1)
Power off the equipment, disconnect them with the power socket, wait for 10 to
20 seconds, and then open the host cover.
2)
Move the equipment to a well-ventilated place to dry the system at least for 24
hours and make sure that the system is fully dried.
3)
Close the host cover, reconnect the system to the power socket, and then power
on.
4)
In case of operation failure or other abnormal situations, please contact Inspur
and get technical support.
3.
Pay attention to the position of system cables and power cables-avoid placing
wires in high foot traffic locations. Please do not place objects on the cables.
4.
Before removing the host cover, and/or touching the internal components,
please allow for the equipment to cool first. To avoid damaging the mainboard,
please power off the system and wait for five seconds, and then remove the
components from the mainboard and/or disconnect the peripheral device from
the system. Please remember that only service technicians trained by Inspur are
authorized to remove the cover of the host, and to remove and replace internal
components.
5.
If there is modem, telecom or LAN options installed in the equipment, please
pay attention to the followings:
Содержание SA5212M4
Страница 22: ...17 Operations 2 Extend or remove the server from the rack 3 Remove the access panel 4 Remove the air baffle ...
Страница 68: ...63 BIOS Setup 1 System Temperature Information 2 System Fan Speed ...
Страница 75: ...70 ...
Страница 86: ...81 BMC Settings ...