60
Chapter Eight Server Installation Guide
Chapter Eight Server Installation Guide
Chapter Eight Server Installation Guide
(picture 4).
Picture 4
4. Make the smooth side of the inner rail confront the side of cabinet, get the
holes on the inner rail and screws on cabinet corresponding with each other well, let the
inner rail cling to the cabinet closely, then push the inner rail in the direction (rear of
the machine) of red arrows shown in (picture 5), and clamp tightly the inner rail with
double-screw bolts.
▲
Special notice: when push the inner rail in the direction of red arrows, if the
inner rail can’t be clamped into the double-screw bolt, slightly loose the four screws
and then push the inner rail again. After the inner rail is clamped tightly, screw down.
Picture 5
5. Repeat step 1~4, install the other inner rail in the corresponding position at the
other side of the cabinet.
8.4 Install Guide Rail into Cabinet
1. Make sure the installation location of the guide rail on the cabinet;
fi
rstly, let
the bearing stubs of the front frame pass through the
fi
xed hole of the cabinet’s angle
rail (picture 6). Based on the depth of the cabinet, properly adjust the back frame and
fi
x the bearing stubs of the back frame to the angle rail at the back of the cabinet.
(Notice:
the front and back frame must be guaranteed at the same level.)
