20
CALORIE
Accumulates calories consumption during training from 0 to maximum 9999
calories. (This data is a rough guide for comparison of different exercise
sessions which cannot be used in medical treatment.)
PULSE
After you hold two hands to the handgrip sensors, the monitor will display your
current heart rate figures. You may set target figure before training. Once your
heart rate is exceeding to the target, the monitor will alarm to remind you.
TEMPERATURE
Displays current room temperature from 0
℃
to 60
℃
.
OPERATION
Installs 2 pieces of 1.5V #3 batteries, then the screen will display as following “Drawing A” and have
“Bi” sound at the same time.
Get access to the set-up mode of TIME/DISTANCE/CALORIES. When you are in each set-up mode.
For instance, the time set-up, when the time value is blinking, you can press "SET" button to adjust the
number. Press "Mode" button for confirmation and skip to next set-up. The set-up of DISTANCE &
CALORIES is the same as TIME set-up.
When you are in PULSE mode, you may press SET button to set target. After setting, press "MODE"
button to confirm and skip to TIME screen. Continuously press "MODE" button will act this circle. If
you do not enter the RPM and PULSE signal or manual set-up time over 4 minutes in this mode, it will
be skip to SLEEP mode shown as "Drawing B".
After the exercise starts and setting up the TIME, DISTANCE, CALORIES. In SCAN mode shown as
"Drawing C". SPEED/TM/DIST/CAL/PULSE will skip to display every 6 seconds. The order is as
below "Drawing C"
You can also press "Mode" button to select single function display.
When there is any function has been preset the target (TIME or DISTANCE or CALORIES), the
function will be counting down from the preset to zero while the training starts. Once the target is
achieved to zero, the monitor start to beep for 8 seconds, and the function will be counting up from
zero directly if the training is going.
RECOVERY
(1) When press "RECOVERY" button, the RECOVERY function will work. At this time only, PULSE
and TIME is working, other function will not be displayed, and the Sensor Input is not available. TIME
start to count down from "00:60". Pulse signal will be blinking according to user's pulse. When
countdown to "0", it will show F1~F6.
(2) LCD display as follows: (RECOVERY start condition & end condition)
