Inspire Home Automation
www.inspirehomeautomation.co.uk
[email protected]
01202 798390
1
1
NS1001 Installation Guide
Rev 1.0
WARNING Electricity is dangerous.
Before commencing work, ensure that you read and understand these instructions and isolate
the relevant circuit.
This product should only be installed by a qualified electrician or heating engineer
and should be installed
in accordance to BS 7671 (IEE Wiring Regulations), or to another equivalent standard.
CAUTION: High Voltage Wires
The NS1001 series is designed to replace an existing wired Thermostat in a property.
If you do not have an existing wired Thermostat then you would need to run cable, or consider using our
NS1002 wireless series.
Once installed, your central heating can be switched on and off in response to commands from the
Thermostat or remotely using a computer or smart phone.
Whats in the box
1 x Assembled Room Thermostat consisting of
1 x Room Thermostat
1 x Wall Mount
1 x Wiring Cover
1 x Thermostat screw pack
2 x Batteries
(If you have ordered a zoned system you will recieve
one set of above per zone)
1 x Gateway
1 x Network Cable
1 x Power Supply
Gateway
Room Thermostat
Batteries
Network Cable
Thermostat
Screw Pack
Power Supply
