facing inward. NOTE: Failure to assemble this part correctly will result in
permanent damage to the machine during use!
B.) Place Right Lower Pedal Arm Assembly (#47) on Front Pivot Shaft (A). Secure using qty 1 Oversized Flat
Washer (#44) and qty 1 M8x20 Hex Bolt (#43).
NOTE: When assembling Pedal Arm put finger inside the
Bearing Pivot to ensure spacer is centered. Without the Spacer centered you will not be able to place the
Pedal Arm on the Shaft.
C.) Place the Right Lower Pedal Arm Assembly (#47) on top of the Styrofoam
Support Block (with Red Dot) so the ball bearing connection assembly sits on top
of the Styrofoam Support Block.
D.) Secure the Right Upper Pedal Arm Assembly (#89) to the Right Lower Pedal Arm
Assembly (#47) as shown below using qty 6 Curved Washers (#29), qty 6 Lock
Washers (#32) and qty 6 M8x16 socket screws (#31).
E.) Place Arm Spacer (#63) on left side of Frame Pivot Shaft (B)
with open end
facing inward. NOTE: Failure to assemble this part correctly will result in
permanent damage to the machine during use!
F.) Place Left Lower Pedal Arm Assembly (#54) on Front Pivot Shaft (B). Secure using, qty 1 Oversized Flat
washer (#44) and qty 1 M8x20 Hex Bolt (#43).
NOTE: When assembling Pedal Arm put finger inside the
Bearing Pivot to ensure spacer is centered. Without the Spacer centered you will not be able to place the
Pedal Arm on the Shaft.
G.) Place the Left Lower Pedal Arm Assembly (#54) on top of the Styrofoam Support
Block (with Red Dot) so the ball bearing connection assembly sits on top of the
Styrofoam Support Block.
H.) Secure the Right Upper Pedal Arm Assembly (#89) to the Right Lower Pedal Arm
Assembly (#54) as shown below using qty 6 Curved Washers (#29), qty 6 Lock
Washers (#32) and qty 6 M8x16 socket screws (#31).
