5
Turn the
180 degrees and choose the 'X Rev'. And touch
the screen if the level is settled.
level
Default: If the calibration is not done well, user can choose the
'default'. Then level will recall the zero setting values at the
factory.
5
Average: To change the number of inputting row data to average
them. It can be set from 1 to 30.
6
Display: To change display options as like brightness, display off
time, etc.
7
Save: To save whatever user has changed, it should be done. If
user doesn't want to save the current changes, just turn off the
power .
8
About: To see the information of the manufacturer.
Go Back: To exit the Display' menu.
'
Touch Calibration: To calibrate the touch panel.
Brightness: To change the brightness of the screen.
Display Off: To change the display on time. The screen will be
off after this time.
Power Off: To change the power on time. The power will be off
after this time.
Line width: To change the width of the tiled direction indicating
line at the POLE mode.
6
1
Three using method:
Operation
horizontal use
vertical use
lie-down use
2
Flat mode: Flat mode is used to adjust the 4 legs machines, as
like laundry machine, etc., very easily. There are shown the 3
points, that makes a plane, with the heights to raise up.
The floated point should be taught by user. It could be P1, P2, P3,
or P4 depend on situation. If user touches the area of the floated
point on the screen, ISE-2DT calculates and displays the heights
of the other 3 points. The floated point should be filled up at the
last after user finishes to adjust the 3 points level.
Note:
Before measuring, to use this flat mode, user also has to set the
parameters.
P1
P2
P3
P4
floated point
P1
should
be
up
2 96mm
.
P2
4 00mm
should
be
up .
P3 doesn’t need to adjust
P4 is floated point
