3
4
3
The main menu is composed as the
picture. Each functions
can be chosen by touching the letters.
following
Main Menu
Spec: To setup the spec. for the FLAT mode.
2
Mode: To change the mode of display.
1
Run: To exit the main menu and display the measuring screen.
Go Back: To exit the 'Spec' menu.
Tolerance: To setup the tolerance of the tilted direction display
line, the green line or bubble means within the tolerance.
Model: 10 memory spaces are given to save the users'
specification setting. And user could recall them later.
X: The width of the setting points.
Y: The length of the setting points.
Pitch: The pitch of the screwed legs at the home appliances or
other machines.
Angle: It is set by 360 deg. normally.
4
Calibration: To calibrate the absolute zero. Please follow the
steps carefully. If not, it can not be guaranteed the angle data.
XY Calibration: Put the level on the surface as following
picture and choose the 'XY 1st'. Then you might see 'XY 1st
Please Touch Screen'. If the level is settled well on the
surface, touch the screen and wait until the level gathers the
data and averages them.
Turn the level 180 degrees and choose the 'XY Rev'. And
touch the screen if the level is settled.
X Calibration: Put the
on the surface
and choose the 'X 1st'. Then you might see 'X 1st Please
Touch Screen'. If the level is settled well on the surface, touch
the screen.
level
as following picture
