17
The wash cycle duration is 10 minutes. At the end of the
cycle the dishwasher emits a series of beeps and “END”
blinks on the display.
If the limescale:
• is completely absent then go to step 5.
• is still present then repeat step 3 and 4.
CAUTION
Do not allow the deliming agent to remain in the
machine longer than recommended by the deliming
agent supplier.
Step 5 - Empty and clean the tank.
Repeat step1.
Note!
• To delime the booster, call your authorized service
company.
D5.2 Prolonged period of inactivity
If the dishwasher is not to be used for a long time, pro-
ceed as follows:
• Close the water supply shutoff valve.
• Completely drain the tank.
• Remove and carefully clean the filters.
• Completely drain the incorporated dispenser hoses,
removing them from the containers. Repeat the pro-
cedure described in the paragraph “Manual activa-
tion” at least 3 times.
• Completely drain the booster by simultaneously pres-
sing the buttons as shown in the figure.
A buzzer indicates completion of drainage.
• Spread a thin film of petroleum jelly over all the stain-
less steel surfaces.
D5.3 Preventive maintenance
The preventive maintenance message “CALL” may be
activated.
Upon reaching the set number of cycles (e.g. 20000),
appears on the display.
This message advises calling a qualified authorized ser-
vice technician for a general check-up on of the state of
the appliance.
NOTICE
: CONTACT YOUR AUTHORIZED SERVICE
COMPANY TO PERFORM MAINTENACE AND
REPAIRS
NOTICE
: Using any parts other than genuine factory
manufactured parts relieves the manufacturer of all war-
ranty and liability.
NOTICE
: Manufacturer reserves the right to change spe-
cifications at any time without notice.
WARNING
The equipment warranty is not valid unless the
appliance is installed, started and demonstrated
under the supervision of factory trained installer.
WARNING
The unit must be installed by Personnel who are
qualified to work with electricity and plumbing.
Improper installation can cause injury to personnel
and/or damage to the equipment. The unit must be
installed in accordance with applicable codes.
D6
RESIDUAL RISKS
The machine has several risks that were not completely
eliminated from a design standpoint or with the installa-
tion of adequate protection devices.
Nevertheless, through this manual the Manufacturer has
taken steps to inform operators of such risks, carefully
indicating the personal protection equipment to be used
by them.
Sufficient spaces are provided for during the machine
installation phases in order to limit these risks.
To preserve these conditions, the corridors and areas
around the machine must always be:
• kept free of obstacles (e.g. ladders, tools, containers,
boxes, etc.);
• clean and dry;
• well lit.
For the Customer’s complete information, the residual
risks remaining on the machine are given below; such
actions are to be considered incorrect and therefore
strictly forbidden.
DETERGENT PRIMING
RINSE AID PRIMING
RESIDUAL
RISK
DESCRIPTION OF HAZARDOUS
SITUATION
Slipping or
falling
The operator can slip due to water or
dirt on the floor.
Burns
The operator deliberately or uninten-
tionally touches some components
inside the machine or dishes at the
outfeed without using gloves or with-
out allowing them to cool. Possible
contact with water above 60°C /
140°F.
Electrocution
Contact with live parts during main-
tenance operations carried out with
the electrical panel powered.
