23
www.insigniaproducts.com
12-Cycle Electric and Gas Dryers
INSTALLATION INSTRUCTIONS
Bottom venting
1
Remove the two rear exhaust retaining screws, then pull out the exhaust duct.
2
Press the tabs on the knockout, then carefully remove the knockout for the
desired vent opening.
3
Push the adapter duct onto the blower housing of the dryer.
4
Connect a 4 in. (10.2 cm) elbow to the 4 in. (10.2cm) duct section, and secure
all joints with aluminum tape. Make sure that the male end of the elbow faces
down through the hole in the bottom from the dryer.
5
Insert the elbow/duct assembly through the rear opening and press it onto
the adapter duct. Secure in place with aluminum tape. The male end of the
duct should protrude 1.5 in. (3.8 cm) out of the dryer to connect the remaining
ductwork.
SIDE VIEW
1.5 in. (3.8 cm)
TOP VIEW
4.5 in. (11.4 cm)
3.5 in. (9.3 cm)
12.1 in. (30.8 cm)
Retaining screw
Rear exhaust duct
DRYER SIDE/BACK VIEW
Adapter duct
Knockout
