12
www.insigniaproducts.com
STEP 5 -
Option 2: Installing on a solid concrete or concrete
block wall (requires Concrete Installation Kit CMK1)
CAUTION:
To prevent property damage or personal injury, never drill into the mortar between the
blocks. Mount the wall plate directly onto the concrete surface.
1
Align the center of the wall plate template (
R
) at the height (
a + b
- 1.5 in.) you determined in the
previous step, make sure that it is level, then tape it to the wall.
2
Drill two pilot holes through the template to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter
masonry drill bit, then remove the template.
3
Insert the concrete wall anchors (
C3
) into the pilot holes and use a hammer to make sure the anchors are
flush with the concrete surface.
4
Align the wall plate (
10
) with the anchors, insert the lag bolts (
C1
) through the lag bolt washers (
C2
),
then through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall
plate.
CAUTION:
• Use only the upper slotted holes to mount the wall plate. Do not use the lower slotted holes.