10
www.insigniaproducts.com
STEP 5 -
Option 1: Installing on a wood stud* wall
Note
: Any drywall covering the wall must not exceed 5/8 in. (16 mm).
1
Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2
Align the center of the wall plate template (
R
) at the height (
a + b
- 1.5 in.) you determined in the
previous step, make sure that it is level, then tape it to the wall.
3
Drill two pilot holes through the template to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter
drill bit, then remove the template.
4
Align the wall plate (
10
) with the pilot holes, insert the lag bolts (
11
) through the lag bolt washers (
12
),
then through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall
plate.
CAUTION:
• Use only the upper slotted holes to mount the wall plate. Do not use the lower slotted holes.
• Install in the center of the studs. Do Not install in drywall alone.