VIDEO
10
SUB WOOFER
SURROUND RIGHT
SPEAKER
FRONT CENTER
SPEAKER
FRONT RIGHT
SPEAKER
RIGHT
LEFT
RIGHT
LEFT
SW OUT
Use this jack on the
middle back panel to
connect another
powered subwoofer
other than the one
supplied.
SURROUND CENTRE
SPEAKER
Getting Started
Connecting the Speakers
Speakers
Connecting the Main ,Center, Rear Speaker
Speaker Polarity
When connecting the speakers, make sure the polarities ( "+"
speaker wire to "+" on the receiver) of speaker wires and
terminals are matched. If the cords are reversed, the sound
will be distorted and will lack bass ("out of phase" effect).
Connecting the Subwoofer
To connect your own powered subwoofer, a mono aural audio
cord (not supplied) is needed (RCA terminal).
This receiver offers a high flexibility for user to use a large
variety of speakers and subwoofers. For more information
please refer to section "
Speaker Setting
" in "Operating Your
Receiver" on page 20.
MAKE SURE TO CONNECT 6-8 OHM SPEAKERS ONLY.
Do not let the bare speaker wires touch each other or any metal
part of this unit. This could damage this unit or the speakers,or both.
Connect the speakers
terminals to your speakers with the wire of
the wire of the proper gauge (keep as short as possible). if the
connections are faulty. no sound will be heard from the speakers.
Method
1
Method 2
Or you also may use banana plug.
SURROUND LEFT
SPEAKER
FRONT LEFT
SPEAKER
You will need to use 7 speakers with the unit (Front Left, Front
Right, Front Center, Surround Left Surround center, Surround
Right and subwoofer). In order to enjoy good surround effects
all six speaker need to be connected to the receiver.
At least two front speakers (Front left and right) are required.
For better sound quality, Center speaker, Surround speakers
and Subwoofer should also be connected. Adding Center and
Surround speakers will enhance surround effects. Adding a
Subwoofer will increase bass response.
If you want to enjoy full range of sound effects, with small
speakers,it is a must to use the subwoofer with the speakers to
maintain adequate bass signal.
1.
2.
3.
Loosen the knob.
Insert the bare wire.[Remove approx 5mm(1/4
) insulation
from the speaker wires.]
Tighten the knob and secure the wire.
Notes
