22
1.3
4S Mount Electrical Box
Before installing the IP Dome Camera in the 4S Electrical Box, please unscrew
and open the Dome Cover with the Security Torx.
Follow the steps below to install the 4S Mount Electrical Box:
Figure: 4S Mount Electrical Box
STEP 1:
Run the wires (Ethernet and power) through the wall.
NOTE:
The Power Cable is omitted if using PoE.
STEP 2:
Disassemble the Dome Camera’s Inner Cover (see the illustration in
1.1 Hard
Ceiling: Step 3
) from the Camera Module.
STEP 3:
Detach the Snap-on Camera Module from the Dome Camera’s Housing/
Pleat by unscrewing the Module-fastened Torx Screw first. Then press the
sides of Camera Module and pull it slightly out of the Housing/ Plate.
