INR LINC 21, Руководство по установке, Страница: 5 / 12

5 ((12))
Before installation
We recommend that an authorised plumber is contacted for installation and service.
Piping should be flushed prior to assembly.
LINC 21 SHOWER MIXER incl. OVERHEAD SHOWER AND HAND
SHOWER
Technical features
Thermostatic mixer is approved by SP (SC0251-14) for more information see approval available on www.sp.se/en
Approved for installation PN10 pressure tests according Temperature at the tapping point must be minimum 50ºC and
maximum 60°C.
Cold water tapping point should not be subjected to involuntary heating. Temperatures above 20ºC are not suitable.
Operating pressures on hot and cold line should be kept as balanced as possible, and from a common source, in order to
ensure the maximum efficiency of the mixer.
Plumbing and installation
An independent water supply both for hot and cold is required.
Large runs of pipework will cause frictional loss of pressure.
If more than one shower valve is installed ensure constant supply of hot and cold water can be maintained.
Hot water supply must always be on the left inlet.
Shut down water supply when plumbing and installing.
Carefully flush pipework before commencing installation.
Installation 150 cc and 160 cc SHOWER MIXER
• We recommend the installation is done using an approved mixing rail or wall box.
• Make sure the temperature regulator are on the right side.
• When the installation is complete, open the main valve and make sure there are no leaks.
Installation SHOWER KIT
Prior to drilling into walls, check there are no hidden electrical wires, cables or water supply pipes.
•
Position the wall bracket (G) on to the console (H) of the rigid riser.
• Fix the rigid riser (B) to the mixer screwing the nut to the mixer’s top outlet, use the supplied washer (A) and decide
correct position using the wall bracket as a template.
• Screw fasteners shall be made in massive construktions such as concrete, studs, special construction detail or
“Våtrumsvägg 2012”. Screw fixings shall not be made solely in the floor or wall plate (SäVa § 2.11.1 & “Våtrumsvägg
2012”). See detailed sketches page 8-9.
• Disassemble the rigid riser from the mixer and drill holes to suit the screws (E).
• Fix the wall bracket (G) to the wall using the supplied screws (E) and place the wall bracket cover (D) over it.
• Secure the rigid riser (B) to the mixer tightening the nut and make sure to use the supplied washer (A).
• Insert the back stem of the console (H) into the wall bracket (D+G) and fix it by tightening the grub screw (F).
• Connect the conical end of the shower hose to the handset (I) and the other end to the bottom outlet of the mixer
paying attention to insert the small sealing washers supplied with the flexible hose on both sides.
• Fit the shower rose (K) to the rigid riser with washer (J) in its place.
• To adjust the height of the shower rose (K) twist the small lever on the console (H) and regulate the top part of the rail
as required.
Operation
In order to regulate the water flow turn the handle (9) counterclockwise to turn on and increase the flow to the head shower,
turn clockwise to turn on and increase the flow to the hand shower.
In order to regulate the water temperature, turn temperature handle (3) clockwise to decrease the water temperature and
counterclockwise to increase it.
The mixer is factory set at 38°C. If you need to reach higher temperature, press the button and turn the handle
counterclockwise.