8 / 11
InPlay NanoBeacon™ IN100 Development Kit
user manual
Designator
Function
Description
J5
External power
supply
External power supply ( 1.1~3.6V input).
When this power supply is available, keep no coin cell
battery installed and switch the programmer board SW1 to
OFF.
J8
Current
measurement
- For normal operation, a jumper needs to be installed
- For current measurement
•
Remove the jumper J8 on the board
•
Power pin 1 (VCC) of J8 with an external power supply
with an ammeter. Initially, set the voltage same as
the voltage presented on J8 pin 2 (VBAT)
•
Press the K1 button to reset the device and run the
user configuration in RAM (refer to the "Run in RAM"
operation in the NanoBeacon
TM
Configuration Tool
User Manual for details)
•
Disconnect the programmer board from the
development board
•
Set the external power supply to the voltage at which
you want to measure the current, and then measure
the current.
J9
RF TX output
connector
The male 3.5mm SMA RF connector for connecting an
external antenna ( Note: antenna is not provided in the kit)
P1
Chip_EN
- Chip_EN ON: Connect pin 1 and 2. This is to enable the
device.
- Chip_EN OFF: Connect pin 2 and 3. This is to disable the
device.
K1
Chip reset
Chip reset button
