INOXPA VEEVALV, Инструкции по установке, обслуживанию и техническому обслуживанию

Страница: 4 / 28

2021/12 1.Safety 3
1. Safety
1.1. INSTRUCTION MANUAL.
This instruction manual contains basic operations which should be fulfilled during the installation, starting and
maintenance.
The information published in the instruction manual is based on updated information.
INOXPA reserves the right to modify this instruction manual without prior notice.
1.2.
START-UP INSTRUCTIONS.
This instruction manual contains vital and useful information to correctly install and maintain your valve.
Not only should the safety instructions indicated in this chapter be observed and fulfilled, but so should the special
measures and recommendations included in the other chapters of this manual. These instructions should be kept in a
safe location near the installation.
1.3.
SAFETY.
1.3.1. Warning symbols.
Danger for persons in general
Danger of injury caused by rotating
equipment parts.
Electrical danger Danger! Caustic or corrosive agents.
Danger! Suspended loads
Danger to the correct operation of the
equipment.
Commitment to safety at the workplace. Protective goggles requirement.
1.4. GENERAL SAFETY INSTRUCTIONS
Read the instruction manual carefully before installing and starting up the valve. Contact
INOXPA in case of doubt.
1.4.1. During the installation.
The
Technical Specifications
of Chapter 8 should always be observed.
The installation and use of the valve should always be carried out in accordance with
applicable regulations regarding health and safety.
Before starting up the valve, verify that the assembly is correct and that the shaft is aligned.
An incorrect alignment and/or excessive force in securing the valve may cause serious
mechanical problems in the valve. Check that the diaphragm has been assembled correctly. If
it has been located incorrectly this may seriously damage the valve.
1.4.2. During operation.
The
Technical Specifications
of Chapter 8 should always be observed. The specified maximum
parameters must NEVER be exceeded.
NEVER touch the valve and/or pipes that are in contact with the liquid during operation. If
working with hot fluids there is a risk of burns.