Inoksan MAYALAMA DOLABI, Инструкция по эксплуатации

Страница: 9 / 28

7
GB
WARNINGS
Installation, modifications and maintenance of the
appliance must be carried out by authorised personnel
in compliance with current safety standarts.
The manufacturer declines all responsibility for failure
to comply with these obligations.
• The instructions contained in this manual give
important regarding security for installing and
maintaining the appliance. The manufacturer
recommends that this manual be carefully stored
in the work zone where it can be consulted by
technicians and workers.
• Electric connection of the appliance must be
according to the instructions given on the technical
data table and electric scheme.
• Disrespect of the instruction given by producer with
the appliance (Use, maintenance, electric connectin,
technical data table and data plate) may compromise
the appliance safety and will result in immediate
loss of the warranty. The manufacturer declines all
responsibility for injury or damage to persons or
things, due to disrespect of the instructions.
• It is avaliable to use this appliance under convection
ovens with 6 or 10 trays or seperately.
INSTALLATION
• The appliance should be placed under an exhaust
hood to remove smoke and smell which may occur
during the cooking process.*
• Position the appliance at least 10 cm from
surrounding walls. This distance may be reduced if
the walls are flameproof or protected by insulating
material.*
• The appliance should be placed on a flat surface by
balancing it due to its four adjustable feet.
• Remove the protective nylon on the appliance. If
sticky particles left on the appliance, clean them
with a suitable solvent.
* : Please take into consideration these sentences if
you need to put a convection oven on the appliance.
WATER CONNECTION
• Make a water installation of 3/4” to the place where
the machine is and connect a spherical valve. The
connection between the machine and the valve
will be by waterspout or galvanised spout and the
machine entry will be 3/4”.
• The machine should be fed by 2-4 bar water at 5-7
0Fh. So, the jet of water will be prevented to be
limed in a short time.
ELECTRICAL CONNECTION
• The appliance should be fed by 230V 50Hz circuit
voltage
• Voltage tolerance should not exceed ±10%.
• The appliance must be connected to a socket with
earthing system.
USERS GUIDE
• All the surfaces of the appliance must be cleaned
and rinsed with little warm soapy water before
operating.
• For the first time you operate the appliance, it smells
a little and you can see some smoke. This is normal
because the appliance is warming for the first time
and it will disappear some after.
• This appliance is avaliable for GN1/1, GN2/1 and
400*600mm containers. Therefor locate the rail
sheets;
*to hole numbered 1 for tray 400*600 mm.,
*to hole numbered 2 for GN 1/1 container,
*to hole numbered 3 for GN 2/1 container.
OPERATION
• Switch on the appliance.
• Adjust the temperature of the thermostat numbered
“2”. When the heater reaches this level, the red