Inocal NYS-1112, Инструкция по эксплуатации

Страница: 8 / 12

7
14
．
Deploy the top board flat. See FIG-15 .raise the top board high enough to see if it fits with the surrounding boards, and then
put down. See FIG-16
FIG-15 deploy the top board FIG-16 Assembling the top board
15
．
When put down the top board, make the power supply lines aim at the
“
U
”
type slot on the top board. See FIG-17. All
these wires should be connected with the outer wires of top board, and make sure they are connected tight. See FIG-18.
FIG-17 put through the wire FIG-18 outer line on top board
16
．
First, fix the lamp holder with screws, and connect the power supply lines. See FIG-19. Then lock the lamp and glass cover
tight. See FIG-20.
17. After that, put the wooden lampshade under the glass cover (be moderate),then lock it with screw. See FIG-21.
18. Take out the warm barothermohygrogram, and put it on the level of panel. Note: do not put the warm barothermohygrogram
under the heat stove. See FIG-22.
FIG-19 fix the pedestal FIG-20 install the glass cover